Technical authority for plastic injection molding machines

Your injection machine, with a passport you can trust

From diagnosing your production line to inspecting used machines, training and technical service. Every job done on a machine is recorded in its permanent passport.

Request a service Did you know?

Inspector independent of the seller
On-site visits at your plant
QR passport on the machine
Permanent, tamper-proof history

+30years in plastic injection molding

+50systemization and line-optimization projects

ERPاپلیکیشن اختصاصی مدیریت فرایند برای سازمان‌ها و کارخانجات ذغال

5levels of on-site training courses

+200مشتری وفادار با بیش از ۲۰ سال خدمت مستمر گروه صنعتی افتاب

24/7خدمات HOT LINE جهت پشتیبانی تولید هفت روز هفته و ۲۴ ساعته

Layer by layer

Open each layer — there is something to discover behind every one

Layers explored ۱ / 4

Productivity

Did you know that by cutting scrap and raising productivity, you can gain the capacity of an injection machine without buying one?

A machine you don't buy needs no capital, no floor space, no extra power and no new operator. You only have to win back capacity your shop is already wasting.

Read the technical answer

+1.8machines of extra capacity in a 10-machine shop, by raising OEE from 55% to 65%

Mold protection

Did you know that with mold protection set correctly, the machine stops by itself before it crushes a stuck part or breaks a core?

Repairing a broken mold can stop production for weeks. In most cases the cause isn't bad luck but a simple setting: the moving platen entered the danger zone with too much speed and pressure.

Read the technical answer

≈ 0target pressure in the danger zone: just enough to overcome friction

Cycle time

Did you know that more than half of an injection cycle is usually spent just cooling the part?

So the fastest way to shorten the cycle is usually not injection speed but the water flowing through the mold's channels.

Read the technical answer

50–80%typical share of cooling in the total cycle time

Energy

Did you know that the hydraulic pump of an older machine runs at full speed even while the machine waits for the part to cool?

The excess energy in these machines passes through the relief valve and turns into heat: you pay once for the electricity and again to cool the oil.

Read the technical answer

30–60%typical electricity savings with a servo pump versus a fixed-speed pump

Materials

Did you know that a part molded from undried material can look perfect while having lost much of its strength?

In materials such as PC, PET and PBT, moisture breaks the polymer chains at melt temperature. The part has the right shape but cracks during assembly or under load.

Read the technical answer

0.02%commonly recommended maximum moisture for polycarbonate before molding

See all